Can-Am Outlander 500 2008 Operator's Manual page 96

Hide thumbs Also See for Outlander 500 2008:
Table of Contents

Advertisement

ENGINE LACKS ACCELERATION OR POWER (cont'd)
6. Engine is under a protection mode.
– Check multi-function gauge display for messages.
– Multifunction gauge CHECK ENGINE indicator lamp is on and display shows
CHECK ENGINE or LIMP HOME, contact an authorized Can-Am dealer.
ENGINE BACKFIRE
1. Exhaust system leakage.
– Contact an authorized Can-Am dealer.
2. Engine is running too hot.
– See ENGINE LACKS ACCELERATION OR POWER.
3. Ignition timing is incorrect or there is an ignition system failure.
– Contact an authorized Can-Am dealer.
ENGINE MISFIRE
1. Fouled/damaged/worn spark plug.
– Clean/verify spark plug and heat range. Replace as required.
2. Water in fuel.
– Drain fuel system and refill with fresh fuel.
VEHICLE CANNOT REACH FULL SPEED
1. Engine.
– See ENGINE LACKS ACCELERATION OR POWER.
2. Parking brake.
– Ensure parking brake is completely removed.
3. Air filter/housing plugged or dirty.
– Check air filter and clean if necessary.
– Check deposits in air filter housing drain.
– Check the position of the air intake tube.
4. CVT dirty or worn-out.
– Contact an authorized Can-Am dealer.
5. Engine is under a protection mode.
– Check multifunction gauge display for messages.
– Multifunction gauge CHECK ENGINE indicator lamp is on and display shows
CHECK ENGINE or LIMP HOME, contact an authorized Can-Am dealer.
TRANSMISSION LEVER IS HARD TO MOVE
1. Transmission gears are in a position that prevents the transmission lever
to work.
– Rock the vehicle back and forth to move the gears in the transmission and
allow the transmission lever to be set.
______________________
94

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Outlander 800 2008Outlander 650 2008

Table of Contents