Use And Operation Solely With The Following Machines; Documents Which Also Apply; Warranty; Declaration Of Conformity - EWM Tetrix 351 Operating Instructions Manual

Intended use

Use and operation solely with the following machines

3.2 Use and operation solely with the following machines
Tetrix 351-551
Tetrix drive 4L
Tetrix 270 hotwire
TIG 450W KDK
TIG 450W HW
 not possible
 possible
3.3

Documents which also apply

3.3.1

Warranty

For more information refer to the "Warranty registration" brochure supplied and our information
regarding warranty, maintenance and testing at www.ewm-group.com!
3.3.2

Declaration of Conformity

The designated machine conforms to EC Directives and standards in terms of its design
and construction:
•
EC Low Voltage Directive (2006/95/EC),
•
EC EMC Directive (2004/108/EC),
This declaration shall become null and void in the event of unauthorised modifications, improperly
conducted repairs, non-observance of the deadlines for the repetition test and / or non-permitted
conversion work not specifically authorised by the manufacturer.
The original copy of the declaration of conformity is enclosed with the unit.
3.3.3

Welding in environments with increased electrical hazards

In compliance with IEC / DIN EN 60974, VDE 0544 the machines can be used in
environments with an increased electrical hazard.
3.3.4

Service documents (spare parts and circuit diagrams)

Do not carry out any unauthorised repairs or modifications!
To avoid injury and equipment damage, the unit must only be repaired or modified by
specialist, skilled persons!
The warranty becomes null and void in the event of unauthorised interference.
•
Appoint only skilled persons for repair work (trained service personnel)!
Original copies of the circuit diagrams are enclosed with the unit.
Spare parts can be obtained from the relevant authorised dealer.
3.3.5

Calibration/Validation

We hereby confirm that this machine has been tested using calibrated measuring equipment, as
stipulated in IEC/EN 60974, ISO/EN 17662, EN 50504, and complies with the admissible tolerances.
Recommended calibration interval: 12 months
18
TIG hot wire





DANGER
TIG cold wire





099-000115-EW501
17.06.2015