Intended Use; Use And Operation Solely With The Following Machines; Documents Which Also Apply; Software Version - EWM Puls Operating Instructions Manual

Intended use

3
Hazards due to improper usage!
The machine has been constructed to the state of the art and any regulations and
standards applicable for use in industry and trade. It may only be used for the welding
procedures indicated at the rating plate. Hazards may arise for persons, animals and
material objects if the equipment is not used correctly. No liability is accepted for any
damages arising from improper usage!
•
The equipment must only be used in line with its designated purpose and by trained or
expert personnel!
•
Do not improperly modify or convert the equipment!
3.1

Use and operation solely with the following machines

This description may only be applied to machines with the M3.7X-K machine control.
3.2

Documents which also apply

•
Operating instructions for the connected welding machines
•
Documents of the optional expansions
3.3

Software version

These instructions apply to the following software version:
1.0.9.0
The software version of the machine control can be displayed in the machine configuration menu
(menu Srv) > see 4.5 chapter.
Machine control – Operating elements
3.4
3.4.1

Overview of control sections

For description purposes, the machine control has been divided into two sections (A, B) to
ensure maximum clarity. The setting ranges for the parameter values are summarised in the
parameter overview section > see 7.1 chapter.
099-0M37XK-EW501
16.07.2018
Use and operation solely with the following machines
WARNING
Intended use
7