Machine Cooling; Workpiece Lead, General - EWM Tetrix 351 Operating Instructions Manual

Damage due to incorrect connection!
Accessory components and the power source itself can be damaged by incorrect
connection!
•
Only insert and lock accessory components into the relevant connection socket when the
machine is switched off.
•
Comprehensive descriptions can be found in the operating instructions for the relevant
accessory components.
•
Accessory components are detected automatically after the power source is switched on.
Using protective dust caps!
Protective dust caps protect the connection sockets and therefore the machine against
dirt and damage.
•
The protective dust cap must be fitted if there is no accessory component being operated
on that connection.
•
The cap must be replaced if faulty or if lost!
Observe documentation of other system components when connecting!
5.2

Machine cooling

To obtain an optimal duty cycle from the power components, the following precautions should be
observed:
•
Ensure that the working area is adequately ventilated.
•
Do not obstruct the air inlets and outlets of the machine.
•
Do not allow metal parts, dust or other objects to get into the machine.
5.3

Workpiece lead, general

Risk of burns due to incorrect connection of the workpiece lead!
Paint, rust and dirt on the connection restrict the power flow and may lead to stray
welding currents.
Stray welding currents may cause fires and injuries!
•
Clean the connections!
•
Fix the workpiece lead securely!
•
Do not use structural parts of the workpiece as a return lead for the welding current!
•
Take care to ensure faultless power connections!
099-000115-EW501
17.06.2015
CAUTION
CAUTION
Design and function
Machine cooling
33