Set The Operating Principle (Conventional/Synergic) - EWM Tetrix 351 Operating Instructions Manual

5.13.2.1 Set the operating principle (conventional/synergic)

0
l
Display
ENTER (enter the menu)
•
Switch off machine at the main switch
•
Press and hold the "welding parameters" button and switch the machine on again at the same
time.
NAVIGATION (navigating in the menu)
•
Parameters are selected by pressing the "welding parameters" button.
•
Set or change the parameters by turning the "welding parameter setting" rotary dial.
EXIT (leave the menu)
•
Select the "Elt" menu item.
•
Press the "welding parameters" button (settings will be applied, machine changes to the
ready-to-operate status).
099-000115-EW501
17.06.2015
ENTER
+
Setting/selection
Exit the menu
Exit
Machine configuration
Settings for machine functions and parameter display
Operating principle
•
on = synergic parameter setting (factory setting)
•
off = conventional parameter setting
Design and function
EXIT
Figure 5-24
TIG Synergic operating principle
NAVIGATION
61