Quanmax QDSP-1000 User Manual page 26

Windows Setup
============
Setup will load support for the following mass storage devices(s):
VIA V-RAID Controller Series(Windows XP/SRV2003)
* To specify additional SCSI adapters, CD-ROM drivers, or special
disk controllers for use with Windows, including those for
which you have a device support disk from a mass storage device
manufacturer, press S.
* If you do not have any device support disks form a amass storage
Device manufacturer, or do not want to specify additional
mass storage devices for use with Windows, press ENTER
S=Specify Addition Device
After the SATA controller driver installation is completed, you should see a screen
similar to below. It indicates that you have installed the SATA controller driver
successfully. You can proceed with the Windows 2000/XP installation.
Windows Setup
============
The following list shows the existing partitions and
unpartitioned space on this computer.
Use for UP and Down ARROW keys to select an item in the list.
To set up Windows XP on the selected item, press ENTER.
To create a partition in the unpartitioned space, press C.
To delete the selected partition, press D.
76317 MB Disk 0 at Id 0 on bus 0 on viamraid [MBR]
C: Partition [NTFS]
ENTER=Install
QDSP-1000/ 1010 User's Manual
ENTER=Continue
D=Delete Partition
F3=Exit
76317 MB <73627 MB free>
F3=Quit
26
Chapter 3