Ir Remote Keypad - Christie Boxer 30 Installation And Setup Manual

ID Component
D LCD Side display panel
E Keypad interface
F Christie TAP Enables
G Electronics-side filter door
H Front IR
I Lamp-side filter door
J Projection lens
K Adjustable feet
L Service compartment
M Tool box
N Rear IR
O LED status indicator
P Shutter LED status indicator
Q Lamp door
R AC lock
S AC Input 2: limited power
T AC Input 1: full power
U Power cord: limited power
V Power cord: full power

IR remote keypad

The IR remote keypad controls the projector by way of wireless communications from a battery-
powered infrared (IR) transmitter.
To use the IR remote, direct the keypad toward the projector's front or rear IR sensor and press a
function key. One of the two IR sensors on the projector will detect the signal and relay the commands
for internal processing. The remote also offers a connector for wired connections to the projector.
Boxer 30 Installation and Setup Manual
020-102017-01 Rev. 1 (11-2015)
Description
Displays the projector menus and status.
Controls the projector.
Android devices to communicate with the projector using near field
communication.
Provides access to the electronics-side air filter.
Receives transmissions from the IR remote.
Provides access to the lamp-side air filter.
A variety of lenses can be used with the projector. Available lenses are
listed in accessories.
Raise or lower these feet when positioning the projector to make sure it
is level on all sides so the displayed image appears rectangular without
any keystone.
Access to fold mirror, optical zoom/focus, and DMD convergence
adjustments.
Provides tools for Christie qualified technicians.
Receives transmissions from the IR remote.
Indicates lamp and power status.
Indicates shutter status.
Access to lamp compartment.
Locks Input 1 power cord.
Use this IEC 320-C14 inlet to connect to an appropriately rated power
cord (component R) provided for your region. For use in limited power
mode.
Use this IEC 309 inlet to connect to an appropriately rated power cord
(component S) provided for your region. For use in full power mode.
Connects the provided power cord appropriately rated for your region to
AC Input 2 for limited power mode.
Connects the provided power cord appropriately rated for your region to
AC Input 1 for full power mode.
Installation and setup
14