Configuring The Rs232 Port; Setting Up The Ethernet - Christie Boxer 30 Installation And Setup Manual

Configuring the RS232 port

Configure the RS232 port to send Christie serial commands using a standard RS232 serial cable.
1. Select Menu > Communications > Projector Communication.
2. Use the down arrow to select Baud Rate.
3. Select the appropriate baud rate and select Enter.
4. Use the down arrow to select Network Routing.
5. Select the type network routing appropriate for your projector and select Enter.

Setting up the Ethernet

Ethernet is setup to obtain an IP address automatically if a DHCP server is on the network. To modify
IP settings, or manually enter an address.
Christie recommends using the Ethernet port on the IMXB as the HDBaseT port is limited to 100 Mb/s.
You cannot change the IP settings using the web interface.
1. From the side panel home page, use the arrow keys to select IP Settings.
2. To set the type of network, select DHCP or Static.
3. If you selected Static, manually enter the network information for the IP Address, Subnet,
and Gateway.
4. Select Apply and select Enter.
5. Select MENU > Communications > Ethernet.
6. Select Device name.
7. Use the up and down keys to enter the name of the projector.
8. Select Enter.
Boxer 30 Installation and Setup Manual
020-102017-01 Rev. 1 (11-2015)
Connecting devices and establishing communication
33