Installation Safety And Warning Guidelines; Light Intensity Hazard Distance - Christie Boxer 30 Installation And Setup Manual

Installation safety and warning guidelines

Read all safety and warning guidelines before installing the projector.
Danger! Failure to comply with the following results in death or serious injury.
This product must be installed within a restricted access location where access can be controlled by the
authority responsible for the location. Only service persons or user, who have been instructed about the
reasons for the restrictions applied to the location and any precautions that shall be taken, shall be
granted access to this location. Hazards that exist with the product include, but are not limited to, the
following:
• Hazardous optical radiation outputted from the front of the lens. Classified as Risk Group 3
under IEC 62471:2006.
• Electrical and burn hazards, if the unit is opened.
• High leakage current (when connected to IT power systems).
• Tools provided in the toolbox shall be used by Christie qualified technicians only.
• This product must be located and positioned in a way as to restrict audience members from
direct access to enter the light beam path.
• For overhead installations, always install safety straps or cables, observe load ratings and all
local applicable safety codes.
• When rigging, stacking or installing the projector in portrait mode, use the rigging frame P/N:
144-112015-XX
Warning! Failure to comply with the following could result in death or serious injury.
• A Christie qualified technician is required for all installations.
• SHOCK HAZARD! Never operate the projector without all of its covers in place.

Light intensity hazard distance

This projector has been classified as Risk Group 3 as per the IEC62471 standard due to possible
hazardous optical and thermal radiation being emitted.
Warning! Failure to comply with the following could result in serious injury.
• PERMANENT/TEMPORARY BLINDNESS HAZARD! No direct exposure to the beam is permitted.
• PERMANENT/TEMPORARY BLINDNESS HAZARD! Operators must control access to the beam
within the hazard distance or install the product at the height (greater than or equal to 3.0 m
from the floor to the beam) that prevents exposure of spectators' eyes within the hazard
distance.
• EXTREME BRIGHTNESS! Do not place reflective objects in the product light path.
The following diagram and table shows the zones for optical and thermal radiation hazard distances:
Boxer 30 Installation and Setup Manual
020-102017-01 Rev. 1 (11-2015)
Introduction
7