Turning The Projector On; Projector Led Status Indicators - Christie Boxer 30 Installation And Setup Manual

Power mode
To connect AC power to the projector:
1. Connect AC power to the appropriate AC inlet on the projector.
2. If using full power mode, to ensure AC power cord does not fall out, pull down the safety
latch and lock in place.
To unplug, press tab and pull up the latch to release.

Turning the projector on

When the projector AC power supply is plugged in, the power is on.
Warning! Failure to comply with the following could result in death or serious injury.
• SHOCK HAZARD! Do not attempt operation if the AC supply is not within the specified voltage
and power range, as specified on the license label.
1. Plug the projector in to AC power.
The projector automatically powers on when plugged in. The side panel display functionality
becomes available.
2. To turn the lamps on, press and hold the Power button until you hear a beep.
Related information
Power requirements (on page 38)

Projector LED status indicators

Identify the LED state colors and meaning.
LED State
Blue Solid
Boxer 30 Installation and Setup Manual
020-102017-01 Rev. 1 (11-2015)
Functionality
• 100 - 130 VAC; 200 - 240 VAC
• Less brightness
Description
Standby Lamps are off. Video electronics are off. Projector
status is OK.
Installation and setup
20