Aastra 415 System Manual page 42

Expansion Stages and System Capacity
Max. number of simultaneous ...
FSK receiver for CLIP detection on analogue network interfaces
FSK transmitter for CLIP display on analogue terminals
Total audio channels for basic voice mail (G.711)
1)
The functions can all be of the same type or used as a mix.
2)
Licence required
3)
Can be used without licence subject to the following restrictions: Voice memory capacity approx. 20 min-
utes, no e-mail notification in the event of new voice messages, no forwarding of voice messages, no call re-
cording, restricted voice mail menu by remote retrieval.
Selectable functions of the mainboard DSP
The DSP on the mainboard provides selectable functions. A description of the indi-
vidual functions can be found as of
The functions are determined in the DSP configuration (
possible combinations are listed, with the maximum number of voice channels. For
this the DSP chip on the mainboard has to be loaded with different firmware. Addi-
tional functions require the use of one or more DSP modules. Some of these func-
tions are subject to a licence.
Tab. 16 Selectable functions of the mainboard DSP
1)
DECT VoIP Audio
4
2
2
3
1)
Licences required (see also
2)
Of relevance only to certain countries such as Brazil
Notes
– To be able to configure VoIP channels on the mainboard's DSP, make
sure that in the DSP view (
G.711.
The configured VoIP mode is valid for all the DSP chips of a node. The
following also applies to this mode:
42
3)
or auto attendant
page
1) 1) 2)
GSM CAS
2 8
2 30
4 8
4 30
"Licences", page 60)
2)
44.
=ym). In
Modem Remarks
Standard configuration
G.711 VoIP channels only, two of them
can be used licence--free.
1
=ym) the VoIP mode parameter is set to
Aastra 415 Aastra 430
2 2
2 2
2 2
Tab. 16 all the
Aastra 415/430 as of R3.2
syd-0344/1.6 – R3.2 – 09.2014