Ip System Phones - Aastra 415 System Manual

wall, you may need some dowel plugs. Screws and dowel plugs are part of the
delivery.
2. Put the telephone with the mounting openings over the heads of the wall
screws and pull the phone downwards to stop it.
3. On the cradle is a small clamp which is flush with the cradle surface. Push it up
with a small flat head screwdriver and remove it from the phone.
4. With the cleat arm towards you and the flat side of the clamp towards the phone
turn the clamp 180° and push it again into the cut-out in the phone cradle. Press
in the clamp till it is flush with the surface and only the feet of the clamp are pro-
truding.
Configuring keys
Configure the keys on analogue phones Aastra 6700a in the WebAdmin terminal
configuration. The phone must be connected during configuration so the key con-
figuration can be stored on the phone immediately. If not, you can load the key
configuration on the phone after connecting the phone, by clicking
configuration on phone.
To load the key configuration on all connected Aastra 6700a series phones, click
Update key configuration for all Aastra 6700a
To load the key configuration stored in the WebAdmin from the connected phone,
dial the function code *#53.
Labelling the phone
1. Remove the cover with the logo on top of the control panel by pressing down
slightly and pushing up.
2. Pull out the designation label on the lugs, label it then push it back again into
the cut-out.
3. Carefully put back the cover with the logo, so that the paper lugs are covered.
Powering the phone
The phone is powered via the FXS line.
4. 8. 4

IP system phones

The installation, powering and connection of the IP system phones Aastra 5360ip,
Aastra 5361ipAastra 5370ipAastra 5380ip and Aastra 2380ip are described in the
System Manual "Aastra Intelligent Net (AIN) and IP system phones".
Aastra 415/430 as of R3.2
syd-0344/1.6 – R3.2 – 09.2014
phones.
Installation
Update key
159