Installing The Radio Units - Aastra 415 System Manual

• Avoid direct sunlight.
• See also technical data in
Note:
If these requirements cannot be met (e.g.outdoor installation), use the
appropriate protective housing.
4. 8. 2. 1

Installing the radio units

Do not remove the cover of the radio unit. (Warranty protection will lapse if the
cover is removed)
Fit the mounting bracket (see
serve the minimum distances (see
Position the DSI socket(s) near the radio unit.
Each radio unit requires one DSI bus (two optional on the SB-8): Do not connect
any other terminals.
The radio units can be powered from the communication server up to the maxi-
mum line length of 1200 m specified for operation (wire diameter 0.5 mm). The
plug-in power supply unit for is the same as the one for the Office 135 charging
bay.
Fig. 71 Dimensional drawing for wall-mounting the mounting bracket
Aastra 415/430 as of R3.2
syd-0344/1.6 – R3.2 – 09.2014
Tab. 130.
Fig. 71 dimensional drawing for wall mounting). Ob-
Fig. 72).
160
37 100
ø screw : 4 mm
Mounting bracket
All dimensions in mm
Installation
155