Interface Cards; Replacing A Defective Interface Card - Aastra 415 System Manual

A licence is transferred to another system of the same type
A licence can only be transferred to a communication server of the same type. To
do so you need to replace the EIM card with the licence information. For the proce-
dure for switching an EIM card see
The mainboard is defective
If you need to replace a defective mainboard, transfer the EIM card from the defec-
tive mainboard onto the new one. For instructions on how to replace the main-
board, see page 198.
The EIM card is defective
In the unlikely event of a defective EIM card, contact your authorized dealer to dis-
cuss the procedure.
For the procedure for switching an EIM card see
6. 3. 3

Interface cards

The different card types, the number of slots and the maximum configuration are
all determined by the system capacity (see Chapter
tem Capacity").
A number of rules have to be observed when fitting the cards (see
mounting rules", page
All configuration data is centrally stored in non-volatile Flash memory. This means
that configuration data is preserved whenever a defective interface card has to be
replaced by a new one.
6. 3. 3. 1

Replacing a defective interface card

A card is replaced by the same card type with the same number of ports.
Procedure:
Warning
Be sure to observe the
1. Carry out preparations (see
2. Remove the housing cover.
Aastra 415/430 as of R3.2
syd-0344/1.6 – R3.2 – 09.2014
page 197.
100.
"Safety regulations", page
"Preparations", page
Operation and Maintenance
page 197.
"3 Expansion Stages and Sys-
"Component
82.
191).
193