Ip Interface Commands; Basic Ip Configuration; Table 4-79 Ip Interface Commands; Table 4-80 Basic Ip Configuration Commands - Edge-Core ES4625 Management Manual

Table 4-78 show ip igmp groups - display description (Continued)
Field Description
Uptime The time elapsed since this entry was created.
Expire The time remaining before this entry will be aged out. (The default is 260 seconds.)
V1Timer The time remaining until the switch assumes that there are no longer any IGMP Version
1 members on the IP subnet attached to this interface. (The default is 400 seconds.)

IP Interface Commands

There are no IP addresses assigned to this router by default. You must manually
configure a new address to manage the router over your network or to connect the
router to existing IP subnets. You may also need to a establish a default gateway
between this device and management stations or other devices that exist on another
network segment (if routing is not enabled).
This section includes commands for configuring IP interfaces, the Address
Resolution Protocol (ARP) and Proxy ARP. These commands are used to connect
subnetworks to the enterprise network.
Command Group

Basic IP Configuration

Address Resolution
Protocol (ARP)
Basic IP Configuration
Command
ip address
ip default-gateway
show ip interface
show ip redirects
ping

Table 4-79 IP Interface Commands

Function
Configures the IP address for interfaces and the gateway router
Configures static, dynamic and proxy ARP service

Table 4-80 Basic IP Configuration Commands

Function
Sets the IP address for the current interface
Defines the default gateway through which this router can reach
other subnetworks
Displays the IP settings for this device
Displays the default gateway configured for this device
Sends ICMP echo request packets to another node on the
network
IP Interface Commands
Mode Page
IC
GC
PE
PE
NE,
PE
4
Page
4-241
4-246
4-242
4-243
4-244
4-244
4-245
4-241