Router Redundancy Commands; Table 4-110 Show Ip Pim Neighbor - Display Description; Table 4-111 Router Redundancy Commands - Edge-Core ES4625 Management Manual

4
Command Line Interface
show ip pim neighbor
This command displays information about PIM neighbors.
Syntax
show ip pim neighbor [ip-address]
ip-address - IP address of a PIM neighbor.
Default Setting
Displays information for all known PIM neighbors.
Command Mode
Normal Exec, Privileged Exec
Example
Console#show ip pim neighbor
Address
--------------- ---------------- -------- -------- -------
10.1.0.254
Console#

Table 4-110 show ip pim neighbor - display description

Field Description
Address IP address of the next-hop router.
VLAN Interface Interface number that is attached to this neighbor.
Uptime The duration this entry has been active.
Expire The time before this entry will be removed.
Mode PIM mode used on this interface. (Only Dense Mode is supported.)

Router Redundancy Commands

Router redundancy protocols use a virtual IP address to support a primary router
and multiple backup routers. The backup routers can be configured to take over the
workload if the master router fails, or can also be configured to share the traffic load.
The primary goal of router redundancy is to allow a host device which has been
configured with a fixed gateway to maintain network connectivity in case the primary
gateway goes down.
Command Groups
Virtual Router Redundancy
Protocol
4-314
VLAN Interface
1 17:38:16 00:01:25

Table 4-111 Router Redundancy Commands

Function
Configures interface settings for VRRP
Uptime Expire Mode
Dense
Page
4-315