Ip Igmp; Ip Igmp Robustval - Edge-Core ES4625 Management Manual

ip igmp

This command enables IGMP on a VLAN interface. Use the no form of this
command to disable IGMP on the specified interface.
Syntax
[no] ip igmp
Default Setting
Disabled
Command Mode
Interface Configuration (VLAN)
Command Usage
IGMP query can be enabled globally at Layer 2 via the ip igmp snooping
command, or enabled for specific VLAN interfaces at Layer 3 via the ip igmp
command. (Layer 2 query is disabled if Layer 3 query is enabled.)
Example
Console(config)#interface vlan 1
Console(config-if)#ip igmp
Console(config-if)#end
Console#show ip igmp interface
Vlan 1 is up
IGMP is enable, version is 2
Robustness variable is 2
Query interval is 125 sec
Query Max Response Time is 10 sec, Last Member Query Interval is 1 sec
Querier is 10.1.0.253
Console#
Related Commands
ip igmp snooping (4-227)
show ip igmp snooping (4-228)

ip igmp robustval

This command specifies the robustness (i.e., expected packet loss) for this
interface. Use the no form of this command to restore the default value.
Syntax
ip igmp robustval robust-value
no ip igmp robustval
robust-value - The robustness of this interface. (Range: 1-255)
Default Setting
2
Command Mode
Interface Configuration (VLAN)
Multicast Filtering Commands
4
4-235