Figure 3-61 Port Broadcast Control - Edge-Core ES4625 Management Manual

Web – Click Port, Port Broadcast Control or Trunk Broadcast Control. Check the
Enabled box for any interface, set the threshold, and click Apply.
CLI – Specify any interface, and then enter the threshold. The following disables
broadcast storm control for port 1, and then sets broadcast suppression at 600
packets per second for port 2.
Console(config)#interface ethernet 1/1
Console(config-if)#no switchport broadcast
Console(config-if)#exit
Console(config)#interface ethernet 1/2
Console(config-if)#switchport broadcast packet-rate 600
Console(config-if)#end
Console#show interfaces switchport ethernet 1/2
Information of Eth 1/2
Broadcast threshold:
LACP status:
Ingress rate limit:
Egress rate limit:
VLAN membership mode:
Ingress rule:
Acceptable frame type:
Native VLAN:
Priority for untagged traffic: 0
GVRP status:
Allowed VLAN:
Forbidden VLAN:
Console#

Figure 3-61 Port Broadcast Control

Enabled, 600 packets/second
Disabled
Disable, 1000M bits per second
Disable, 1000M bits per second
Hybrid
Disabled
All frames
1
Disabled
1(u),
3
Port Configuration
4-143
4-149
4-149
4-152
3-105