Table 4-2 Configuration Command Modes - Edge-Core ES4625 Management Manual

4
Command Line Interface
To enter the other modes, at the configuration prompt type one of the following
commands. Use the exit or end command to return to the Privileged Exec mode.
Mode Command
Line line {console | vty}
Access access-list ip standard
Control List access-list ip extended
access-list ip mask-precedence
access-list mac
access-list mac mask-precedence
DHCP ip dhcp pool
Interface interface {ethernet port | port-channel id| vlan id} Console(config-if)#
VLAN vlan database
MSTP spanning-tree mst-configuration
Router router {rip | ospf | dvmrp | pim}
Class Map class map
Policy Map policy map
For example, you can use the following commands to enter interface configuration
mode, and then return to Privileged Exec mode
Console(config)#interface ethernet 1/5
. .
.
Console(config-if)#exit
Console(config)#
4-8

Table 4-2 Configuration Command Modes

Prompt
Console(config-line)#
Console(config-std-acl)
Console(config-ext-acl)
Console(config-ip-mask-acl)
Console(config-mac-acl)
Console(config-mac-mask-acl)
Console(config-dhcp)
Console(config-vlan)
Console(config-mstp)#
Console(config-router)
Console(config-cmap)
Console(config-pmap)
Page
4-11
4-87
4-121
4-143
4-188
4-176
4-254
4-265
4-299
4-308
4-219
4-221