Figure 3-155 Pim-Dm Interface Settings - Edge-Core ES4625 Management Manual

3
Configuring the Switch
Web – Click Routing Protocol, PIM-DM, Interface Settings. Select a VLAN, enable or
disable PIM-DM for the selected interface, modify any of the protocol parameters as
required, and click Apply.
CLI – This example sets the PIM-DM protocol parameters for VLAN 2, and displays
the current settings.
Console(config)#interface vlan 2
Console(config-if)#ip pim dense-mode
Console(config-if)#ip pim hello-interval 60
Console(config-if)#ip pim hello-holdtime 210
Console(config-if)#ip pim trigger-hello-interval 10
Console(config-if)#ip pim join-prune-holdtime 60
Console(config-if)#ip pim graft-retry-interval 9
Console(config-if)#ip pim max-graft-retries 5
Console(config-if)#end
Console#show ip pim interface 2
Vlan 2 is up
PIM is enabled, mode is Dense.
Internet address is 10.1.1.253.
Hello time interval is 60 sec, trigger hello time interval is 10 sec.
Hello holdtime is 210 sec.
Join/Prune holdtime is 60 sec.
Graft retry interval is 9 sec, max graft retries is 5.
DR Internet address is 10.1.1.253, neighbor count is 0.
Console#
3-274

Figure 3-155 PIM-DM Interface Settings

4-190
4-309
4-310
4-310
4-311
4-311
4-312
4-312
4-313