4
Command Line Interface
Example
Console(config)#router dvmrp
Console(config-router)#end
Console#show router dvmrp
Admin Status
Probe Interval
Nbr expire
Minimum Flash Update Interval
prune lifetime
route report
Default Gateway
Metric of Default Gateway
Console#
Related Commands
ip dvmrp (4-303)
show router dvmrp (4-305)
probe-interval
This command sets the interval for sending neighbor probe messages to the
multicast group address for all DVMRP routers. Use the no form to restore the
default value.
Syntax
probe-interval seconds
no probe-interval
seconds - Interval between sending neighbor probe messages.
(Range: 1-65535)
Default Setting
10 seconds
Command Mode
Router Configuration
Command Usage
Probe messages are sent to neighboring DVMRP routers from which this
device has received probes, and is used to verify whether or not these
neighbors are still active members of the multicast tree.
Example
Console(config-router)#probe-interval 30
Console(config-router)#
4-300
: enable
: 10
: 35
: 5
: 7200
: 60
: 0.0.0.0
: 0