Pim-Dm Multicast Routing Commands; Table 4-109 Pim-Dm Multicast Routing Commands; Router Pim - Edge-Core ES4625 Management Manual

4
Command Line Interface

PIM-DM Multicast Routing Commands

Command

router pim

ip pim dense-mode
ip pim hello-interval
ip pim hello-holdtime
ip pim trigger-hello-interval
ip pim join-prune-holdtime
ip pim graft-retry-interval
ip pim max-graft-retries
show router pim
show ip pim interface
show ip pim neighbor
router pim
This command enables Protocol-Independent Multicast - Dense Mode (PIM-DM)
globally for the router and to enter router configuration mode. Use the no form to
disable PIM-DM multicast routing.
Syntax
[no] router pim
Default Setting
Disabled
Command Mode
Global Configuration
Command Usage
This command enables PIM-DM globally for the router. You also need to
enable PIM-DM for each interface that will support multicast routing using the
ip pim dense-mode command (page 4-309), and make any changes
necessary to the multicast protocol parameters.
Example
Console(config)#router pim
Console#show router pim
Admin Status: Enabled
Console#
4-308

Table 4-109 PIM-DM Multicast Routing Commands

Function
Enables PIM globally for the router
Enables PIM on the specified interface
Sets the interval between sending PIM hello messages
Sets the time to wait for hello messages from a neighboring
PIM router before declaring it dead
Sets the maximum time before sending a triggered PIM
Hello message
Configures the hold time for the prune state
Configures the time to wait for a Graft acknowledgement
before resending a Graft message
Configures the maximum number of times to resend a Graft
message if it has not been acknowledged
Displays the global PIM configuration settings
Displays information about interfaces configured for PIM
Displays information about PIM neighbors
Mode Page
GC 4-308
IC 4-309
IC 4-310
IC 4-310
IC 4-311
IC 4-311
IC 4-312
IC 4-312
NE, PE 4-313
NE, PE 4-313
NE, PE 4-314