Ip Interface Commands; Basic Ip Configuration; Ip Address; Table 4-75 Ip Interface Commands - Edge-Core ES4612 Management Manual

4
Command Line Interface

IP Interface Commands

There are no IP addresses assigned to this router by default. You must manually
configure a new address to manage the router over your network or to connect the
router to existing IP subnets. You may also need to a establish a default gateway
between this device and management stations or other devices that exist on another
network segment (if routing is not enabled).
This section includes commands for configuring IP interfaces, the Address
Resolution Protocol (ARP) and Proxy ARP. These commands are used to connect
subnetworks to the enterprise network.
Command Group

Basic IP Configuration

Address Resolution
Protocol (ARP)
Basic IP Configuration
Command

ip address

ip default-gateway
show ip interface
show ip redirects
ping
ip address
This command sets the IP address for the currently selected VLAN interface. Use
the no form to restore the default IP address.
Syntax
ip address {ip-address netmask | bootp | dhcp} [secondary]
no ip address
• ip-address - IP address
• netmask - Network mask for the associated IP subnet. This mask identifies
the host address bits used for routing to specific subnets.
• bootp - Obtains IP address from BOOTP.
• dhcp - Obtains IP address from DHCP.
• secondary - Specifies a secondary IP address.
4-236

Table 4-75 IP Interface Commands

Function
Configures the IP address for interfaces and the gateway router
Configures static, dynamic and proxy ARP service

Table 4-76 Basic IP Configuration Commands

Function
Sets the IP address for the current interface
Defines the default gateway through which this router can reach
other subnetworks
Displays the IP settings for this device
Displays the default gateway configured for this device
Sends ICMP echo request packets to another node on the
network
Page
4-236
4-241
Mode Page
IC 4-236
GC 4-238
PE 4-239
PE 4-239
NE, PE 4-239