Loop_Detect Command - Planet Networking & Communication WGSW-48000 User Manual

6.3.19 Loop_detect Command

Loop_detect enable
Description:
This command is used to enable port self-loop detection.
Syntax:
loop_detect enable
Mode
Global Config
loop_detect disable
Description:
This command is used to disable port self-loop detection.
Syntax:
loop_detect disable
Mode
Global Config
loop_detect recovertime
Description:
This command is used to set the recover time.
Syntax:
loop_detect recovertime <0...65535>
Parameters:
<0...65535>
Mode
Global Config
loop detect trytorecover
Description:
This command is used to try to recover all the selfloop port immediately
Syntax:
loop_detect trytorecover
Mode
Global Config
256
User's Manual of WGSW-48000