Static Address - Planet Networking & Communication WGSW-48000 User Manual

The page includes the following fields:
Object
• L2 Table Aging Enable
• Aging Time
• Clear L2 Dynamic
Entries
• Entry
• Source MAC
•
Port
•
VLAN ID
•
Type
• Reload L2 Table
• L2 Entry Lookup

4.11.3 Static Address

A static address can be assigned to a specific interface on this switch. Static addresses are bound to the assigned interface and
cannot be moved. When a static address is seen on another interface, the address will be ignored and will not be written to the
address table (see Figure
This Static Address page provides a way to add, delete MAC addresses in the L2 address table.
The page includes the following fields:
Object
• Add
Description
Enable or Disable switch L2 Table aging capability.
Specifies the amount of time the MAC address remains in the L2 table before it is timed
out, if no traffic from the source is detected. Enter "0" means to disable aging too.
Click on the button to clear the dynamic MAC address table.
Indicates the sequence number for valid MAC address in the L2 address table.
Indicates the valid MAC address in the L2 address table.
Indicates the port number.
Indicates the VLAN ID the valid MAC address belongs to.
Indicates the MAC address type, either static or dynamic.
Retrieves current L2 address table.
To seach if MAC existed in L2 Table by entering desired MAC and its VLAN ID and then
click on "Lookup" button.
4-11-3)
Figure 4-11-3 Static Address
Description
Clickes on this button to inserts a static MAC address into the L2 address table.
137
User's Manual of WGSW-48000