Planet Networking & Communication WGSW-48000 User Manual page 142

• Restore Configuration
to Factory Defaults
You can also check the PWR LED at the front panel to identify the System is load completely or not.
If the PWR LED is blinking, then it is in the firmware load stage; if the PWR LED light on, you can
use the WEB browser to login the Switch.
This option will restore the switch configuration to factory defaults. All
configuration will be removed.
Figure 4-11-9 Reboot dialogue
Figure 4-11-10 Reboot message
142
User's Manual of WGSW-48000