Octane Fitness Q47e Operation Manual page 50

"NO HR" is • Grasp each contact heart rate grip sensor so the contact sensor portion of the grip
displayed when
doing heart rate
• Grip the contact sensors firmly and keep your hands steady and in place.
controlled programs
• Have someone else try the grips to see if it works for him/her.
and grasping the
• If "NO HR" is still displayed, contact your local dealer for service.
contact heart rate
sensors
Heart rate readout Chest strap
seems • There may be interference with another electrical product (lights, TV, personal stereo,
inaccurate (too high
or too low)
• Put water between your skin and the ribbed electrodes on the back of the chest strap.
• Another person in the same workout area may be wearing a chest strap. Have the
• The chest strap may be too loose. Adjust the elastic strap so that the strap is snug
• Have someone else try the transmitter to see if the reading seems accurate for him/
Contact heart rate sensors
• Make sure you are grasping the grips firmly and steadily.
• Have someone else try the grips to see if the reading seems accurate for him/her.
• If the issue persists, contact your local dealer for service.
Console blinks on • Check the power cord connections. Make sure the connections are secure from the
/ off
• Console connections could be faulty. See assembly instructions to check connections.
• If the issue persists, contact your local dealer for service.
Fan does not work • Console connections could be faulty. See assembly instructions to check connections.
• If the issue persists, contact your local dealer for service.
Machine goes into • This is most likely a speed sensor issue; contact your local dealer for service.
pause mode after a
short time
LED lights are • Press and hold the Pause Clear button for five seconds to enter sleep mode.
always on
LED always toggling • Press the Enter button to stop the LED screen from toggling.
Console LEDs are • Enter User Set-up, by pressing and holding the Level (/) keys for three seconds.
not bright enough • Press any (/) key until "BRIT" displays in the matrix window.
• Press Enter until the LEDs are set at the desired brightness.
• Press any (/) key until "EXIT" displays in the matrix window, then press Enter.
• If the brightness is set to "8" (the brightest level) and the LEDs are still dim, contact
Unable to activate • Check to see that MOM mode is enabled. Enter User Set-up by pressing and holding
Movement
Management (MOM) • Press any (/) key until "MOM" displays in the matrix window.
Mode • Press Enter until "On" is displayed.
• Press any (/) key until "EXIT" displays in the matrix window, then press Enter.
• Press and hold the Program (/) keys for three seconds to activate MOM mode.
42
rests in the palm of your hand.
wireless network, MP3 players, phones, etc.). Turn off any other electrical product to
see if there is interference.
This can improve the electrical connection.
person relocate to a distance of 3-4 feet away if possible.
against your body.
her.
transformer into the machine base and to the wall outlet.
your local dealer for service.
the Level (/) keys for three seconds.