Octane Fitness Q47e Operation Manual page 40

Beep
30:30 rest Minutes
Brightness (Brit)
exit
X-Mode
To customize the X-Mode feature, press and hold the X-Mode button for three seconds, or until you hear
a beep. You can then customize two characteristics of X-Mode:
X-Mode On time
X-Mode Off time
32
You may turn the console sounds "On" or "OFF". The original setting
is "On".
You may set the 30:30 program rest time from 1 to 5 minutes (in whole
minutes only). The original setting is 3 minutes.
You can adjust the intensity or brightness of the console LEDs, choos-
ing any value between 1 and 8. A higher number represents more
light. The original setting is 8.
When EXIT is displayed in the matrix window, press Enter to leave
User Set-up. All of your selections will be saved and will become the
new standard settings for your machine. They may be changed at any
time by repeating these set-up procedures.
The length of each X-Mode interval. The original setting is 1:00.
Use the Time (/) buttons to increase or decrease this interval
(displayed in the X-Mode window), choosing any value between 0:15
and 10 minutes, in increments of 0:15. Press Enter to save the new
X-Mode interval length. To exit without changing the value, press
Pause Clear.
The length of time between X-Mode intervals. The original setting is
1:00. Use the Time (/) buttons to increase or decrease this inter-
val, choosing any value between 0:15 and 10 minutes, in increments
of 0:15. Press Enter to save the new time between X-Mode intervals.
To exit without changing the value, press Pause Clear.
Once you have saved your selections, they are set as the new stan-
dard for your machine—you don't need to reset them for each use.