Replacing Engine Oil Filter; Replacing Transmission Oil - Hisun HS 500 Owner's Manual

① Oil Level
② Dipstick

■ Replacing Engine Oil Filter

CAUTION
To avoid personal injury:

Be sure to stop the engine before changing
the oil filter cartridge.

Allow engine to cool down sufficiently, oil
can be hot and can burn.
1. Park the vehicle on a flat surface, remove the
seat and open the adjustment hatch cover.
2. Remove the oil filter.
3. Put a film of clean engine oil on the rubber
seal of the new filter.
4. Tighten the filter quickly until it contacts the
mounting surface.
Tighten filter by hand an additional 1/2 turn
only.
5. After the new filter has been replaced, the
engine oil normally decreases a little. Make
sure that the engine oil does not leak through
the seal and check the oil level on the dipstick.
Then replenish the engine oil up to the
prescribed level.
PERIODIC SERVICE
① Bolt;
③ "O" seal ring;
IMPORANT:

To prevent serious damage to the engine, use
only a genuine filter.

■ Replacing Transmission Oil

CAUTION
To avoid personal injury:

Be sure to stop the engine before changing
oil.

Allow engine to cool down sufficiently, oil
can be hot and can burn.
1. Park the vehicle on a flat surface, raise the
cargo bed, and mount the safety support.
2. Put a film of clean transmission oil;
3. Quickly tighten the filter until it contacts the
mounting surface, tighten it an additional 1
turn only.
4. After running the engine for a few minutes,
stop the engine and check the oil level again.
Add oil to the prescribed level.
Oil capacity
11-12
② Cover
④ Engine oil filter
[Filter exchanged] 1L (1.05U.S. qts.)