Replacing Engine Oil Filter; Replacing Transmission Oil - Hisun VECTOR 500 Owner's Manual

4. Fill with the new oil up to the upper notch on
the dipstick.
(See "LUBRICANTS, FUEL AND COOLANT"
in "MAINTENANCE" section.)
[Filter exchanged]
Oil capacity
[Filter non-exchanged] 1.6L (1.68U.S. qts.)
① Oil Lever
② Dipstick

■ Replacing Engine Oil Filter

CAUTION
To avoid personal injury:

Be sure to stop the engine before
changing the oil filter cartridge.
Periodic Service

1.
2.
1.8L (1.89U.S. qts.)
3.
4.
5.
IMPORANT:


■ Replacing Transmission Oil

To avoid personal injury:
10-12
Allow engine to cool down sufficiently,
oil can be hot and can burn.
Park the vehicle on a flat surface, remove
the seat and open the adjust hatch cover.
Remove the oil filter.
Put a film of clean engine oil on the rubber
seal of the new filter.
Tighten the filter quickly until it contacts the
mounting surface.
Tighten filter by hand an additional 1/2 turn
only.
After the new filter has been replaced, the
engine oil normally decreases a little.
Make sure that the engine oil does not leak
through the seal and check the oil level on
the dipstick. Then replenish the engine oil
up to the prescribed level.
① Bolt; ② Cover
③ "O" seal ring;
④ Engine oil filter
To prevent serious damage to the engine,
use only a genuine filter.
CAUTION