Hisun HS 500 Owner's Manual page 80

Meter warning fault code：
3
F00005
Meter warning fault code：
4
F00003
No electrical power
5
connected
No meter alarm, UTV can
6 electrify
7 No meter alarm
Figure 1：Fuses box
① ECU dedicated fuse
2. Open the main switch, only steering left or right is power-assisted.
S/N Fault phenomenon
1 No meter alarm
Meter warning fault code：
2
F00001 or F00002
ELECTRIC POWER STEERING SYSTEM
Low voltage in storage battery
Motor is damaged or driving
circuit in motor is damaged or
power motor special fuses are
blown.
Main fuses melted.
ECU initialization choose pin
connector with poor contact (sees
attached figure 2), or in the wire
cable is disconnect
ECU is damaged
ECU damaged
Sensor
connector with bad contact or
ECU damaged
Figure 2：ECU initialization connector's position
① ECU initialization connector
Fault point
damaged, sensor's
15-9
Charge storage battery,
replace it if necessary.
Replace fuses, to dealer
for repair
Replace fuses
Reinsert well, replace
connector or repair cables.
To dealers for repair.
Solution
To dealers for repair.
To dealer for repair.