Checking And Refueling; Checking Coolant Level - Hisun HS 500 Owner's Manual

Hide thumbs Also See for HS 500:
Table of Contents

Advertisement

■ Visual Inspection
Look around and under the vehicle for such items
as loose bolts, trash build-up, oil or coolant leaks,
broken or worn parts.

■ Checking and Refueling

CAUTION
To avoid personal injury:
Do not smoke while refueling.
Be sure to stop the engine before refueling.
Turn the key switch to "ON", check the amount
1.
of fuel by fuel gauge
2.
Fill fuel tank when fuel gauge shows1/4 or less
fuel in tank.
① Fuel tank cap
Fuel tank capacity
IMPORTANT
If oil level is low, do not run engine.
Checking engine oil level
1.
Park the vehicle on a flat surface with engine
off, raise the cargo bed, mount the safety
support.
2.
To check the oil level, draw out the dipstick,
wipe it clean, replace it, and draw it out again,
check to see if the level id too low, add new oil
to the prescribed level at the oil inlet.
PERIODIC SERVICE
① Oil Level
② Dipstick
IMPOTTANT
If oil level is low, do not run engine

■ Checking Coolant Level

TO avoid personal injury
1. Park the vehicle on a flat surface with engine
off, raise the cargo bed, mount the safety support.
2.
the "FULL" and" LOW" marks of recovery tank.
28L
3.
evaporation, add water only up to the full level. In
case of leakage add anti-freeze and water in the
specified mixing ratio up to the full level.(see flush
cooling system and changing coolant in EVERY 2
YEARS in PERIODIC SERVICE section)
11-3
CAUTION
Do not remove radiator cap while coolant
is hot .when cool .slowly rotate to the first
stop and allow sufficient time for excess
pressure to escape removing the cap
completely.
Check to see that the coolant level is between
When the coolant level drops due to

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Hs 700

Table of Contents