Replacing Engine Oil - Hisun HS 200UTV-2 Owner's Manual

Introduction HS 200UTV-2/HS 250UTV-2

oil can be hot and can burn.
1. Park the vehicle on flat surface and
remove the seat, open the adjust hatch
cover.
2. To drain the used oil, remove the drain
plug at the bottom of the engine and
completely drain the oil into an oil pan.
3. After draining, reinstall the drain plug.
4. Fill with the new oil up to the upper notch
on the dipstick.
(See "LUBRICANTS,
COOLANT" in "MAINTENANCE" section.)
[Filter exchanged]
Oil capacity
[Filter non-exchanged] 1.6L (1.68U.S. qts.)
①~② Oil level is acceptable within this range
③ Dipstick ④ Oil inlet
① Drain plug
■ Replacing Engine Oil Filter
To avoid personal injury:


1.
FUEL AND
2.
3.
1.8L (1.89U.S. qts.)
4.
① Bolt;
③ "O" seal ring;
IMPORANT:
 To prevent serious damage to the engine,
1-45
CAUTION
Be sure to stop the engine before
changing the oil filter cartridge.
Allow engine to cool down sufficiently,
oil can be hot and can burn.
Park the vehicle on a flat surface and
raise the cargo bed.
Remove the oil filter.
Put a film of clean engine oil on the rubber
seal of the new filter.
After the new filter has been replaced, the
engine oil normally decreases a little.
Make sure that the engine oil does not
leak through the seal and check the oil
level on the dipstick. Then replenish the
engine oil up to the prescribed level.
② Cover
④ Engine oil filter
use only a genuine filter.