Programming (Matching) Of The Remote Controller And The Receiver - Dog trace d–control 440 User Manual

Programming (matching) of the remote controller and the receiver

Every remote controller has its own RF operational code. Programming of the remote controller with
the receiver (collar) will be accomplished during the fi rst use of the DOGtrace™ d–control set or
with a new remote controller or a receiver (when one or the other is lost). This operation will enable
you to match your remote controller to the delivered receiver (collar).
IMPORTANT: Before programming is started (before the fi rst use of your receiver or code
rewriting) make sure that no one else uses his/her d–control or another product made by
DOGtrace™ in your neighbourhood – your receiver could randomly receive the code from
the other remote controller and set itself to it. If this happens, program your receiver
once again using your remote controller.
Turn on your transmitter.
Select dog A on the remote controller.
Touch the lower part of your remote controller to the target on your receiver (see the photo on
page 8). The green LED will be permanently lit and after some 3 seconds, it will switch to the
programming mode, indicated by fl ashing of the red and green LED at the same time.
Now take your transmitter away and press down the sound signal button
controller. The codes will be matched in this step and your receiver will produce a sound signal.
Proceed in the same way when programming the second receiver (for the second collar for
d–control 442).
on your remote
9