Synchronising Ball Dropper With Remote Controller; How To Use Remote Controller; For The Best Results - Dog trace DBM01 User Manual

Synchronising ball dropper with remote controller

Each ball dropper has a unique operation code. Before fi rst use, ball dropper and remote
controller need to be synchronized.
IMPORTANT:
Before you start synchronising the devices, make sure no other DOGtrace™ system
is used close to you. Your ball dropper might accept a code of another remote
controller accidentally. If this happens, repeat the synchronization procedure.
● Remove ball from the ball dropper.
● In off -state, place the bottom part of the remote controller to the upper edge of the ball
dropper (see picture on page 7) and hold it there. Red indicator light blinks once.
After that, greed indicator is lit up for 3 seconds and then both red and green indicator
lights start blinking. The ball dropper is ready for synchronisation. Now remove the
remote controller from the ball dropper and press the audio signal button.
The ball dropper emits an audio signal indicating the synchronisation was successful.

How to use remote controller

Remote controller DOGtrace™ for DBM01 off ers the following functions:
● By pressing the button
● By pressing the button
● By pressing the button

For the best results

● Before using, check battery status in both the ball dropper and the remote controller.
Replace batteries if necessary.
● Battery performance decreases slightly in temperatures below 0 °C. If possible, keep the
remote controller in warm (in your pocket for instance) and take it out only when using.
8
, a ball is released.
, a ball and an audio signal are released at the same time.
, an audio signal only is released.