Pix 515/515E Default Configuration; Accessing The Command-Line Interface - Cisco PIX 500 Series Configuration Manual

Accessing the Command-Line Interface

The configuration consists of the following commands:
interface management 0/0
ip address 192.168.1.1 255.255.255.0
nameif management
security-level 100
no shutdown
asdm logging informational 100
asdm history enable
http server enable
http 192.168.1.0 255.255.255.0 management
dhcpd address 192.168.1.2-192.168.1.254 management
dhcpd lease 3600
dhcpd ping_timeout 750
dhcpd enable management

PIX 515/515E Default Configuration

The default factory configuration for the PIX 515/515E security appliance configures the following:
•
•
•
The configuration consists of the following commands:
interface ethernet 1
ip address 192.168.1.1 255.255.255.0
nameif management
security-level 100
no shutdown
asdm logging informational 100
asdm history enable
http server enable
http 192.168.1.0 255.255.255.0 management
dhcpd address 192.168.1.2-192.168.1.254 management
dhcpd lease 3600
dhcpd ping_timeout 750
dhcpd enable management
Accessing the Command-Line Interface
For initial configuration, access the command-line interface directly from the console port. Later, you
can configure remote access using Telnet or SSH according to
If your system is already in multiple context mode, then accessing the console port places you in the
system execution space. See
multiple context mode.
If you want to use ASDM to configure the security appliance instead of the command-line interface, you
Note
can connect to the default management address of 192.168.1.1 (if your security appliance includes a
factory default configuration. See the
Cisco Security Appliance Command Line Configuration Guide
2-4
The inside Ethernet1 interface. If you did not set the IP address in the configure factory-default
command, then the IP address and mask are 192.168.1.1 and 255.255.255.0.
The DHCP server is enabled on the security appliance, so a PC connecting to the interface receives
an address between 192.168.1.2 and 192.168.1.254.
The HTTP server is enabled for ASDM and is accessible to users on the 192.168.1.0 network.
Chapter 3, "Enabling Multiple Context Mode,"
Chapter 40, "Managing System Access."
"Factory Default Configurations" section on page
Chapter 2 Getting Started
for more information about
2-1.). On the
OL-12172-03