Asa 5510 And Higher Default Configuration - Cisco PIX 500 Series Configuration Manual

Chapter 2 Getting Started
•
•
The configuration consists of the following commands:
interface Ethernet 0/0
switchport access vlan 2
no shutdown
interface Ethernet 0/1
switchport access vlan 1
no shutdown
interface Ethernet 0/2
switchport access vlan 1
no shutdown
interface Ethernet 0/3
switchport access vlan 1
no shutdown
interface Ethernet 0/4
switchport access vlan 1
no shutdown
interface Ethernet 0/5
switchport access vlan 1
no shutdown
interface Ethernet 0/6
switchport access vlan 1
no shutdown
interface Ethernet 0/7
switchport access vlan 1
no shutdown
interface vlan2
nameif outside
no shutdown
ip address dhcp setroute
interface vlan1
nameif inside
ip address 192.168.1.1 255.255.255.0
security-level 100
no shutdown
global (outside) 1 interface
nat (inside) 1 0 0
http server enable
http 192.168.1.0 255.255.255.0 inside
dhcpd address 192.168.1.2-192.168.1.254 inside
dhcpd auto_config outside
dhcpd enable inside
logging asdm informational

ASA 5510 and Higher Default Configuration

The default factory configuration for the ASA 5510 and higher adaptive security appliance configures
the following:
•
•
•
OL-12172-03
The DHCP server is enabled on the security appliance, so a PC connecting to the VLAN 1 interface
receives an address between 192.168.1.2 and 192.168.1.254.
The HTTP server is enabled for ASDM and is accessible to users on the 192.168.1.0 network.
The management interface, Management 0/0. If you did not set the IP address in the configure
factory-default command, then the IP address and mask are 192.168.1.1 and 255.255.255.0.
The DHCP server is enabled on the security appliance, so a PC connecting to the interface receives
an address between 192.168.1.2 and 192.168.1.254.
The HTTP server is enabled for ASDM and is accessible to users on the 192.168.1.0 network.
Cisco Security Appliance Command Line Configuration Guide
Factory Default Configurations
2-3