Transferring An Image Onto An Ssm - Cisco PIX 500 Series Configuration Manual

Chapter 22 Managing the AIP SSM and CSC SSM
Software version:
App. name:
App. version:
Data plane Status:
Status:
HTTP Service:
Mail Service:
FTP Service:
Activated:
Mgmt IP addr:
Mgmt web port:

Transferring an Image onto an SSM

For an intelligent SSM, such as the AIP SSM or CSC SSM, you can transfer application images from a
TFTP server to the SSM. This process supports upgrade images and maintenance images.
If you are upgrading the application on the SSM, the SSM application may support backup of its
Note
configuration. If you do not back up the configuration of the SSM application, it is lost when you transfer
an image onto the SSM. For more information about how the SSM supports backups, see the
documentation for the specified SSM.
To transfer an image onto an intelligent SSM, perform the following steps:
Create or modify a recovery configuration for the SSM.
Step 1
a.
b.
OL-12172-03
Trend Micro InterScan Security Module Version 5.0
Trend Micro InterScan Security Module
Version 5.0
Up
Up
Up
Up
Up
Yes
10.23.62.92
8443
Determine if there is a recovery configuration for the SSM. Use the show module command with
the recover keyword:
hostname# show module slot recover
where slot is the slot number occupied by the SSM.
If the recover keyword is not valid, a recovery configuration does not exist. This keyword is
available only when a recovery configuration exists for the SSM.
When the adaptive security appliance operates in multiple context mode, the configure
Note
keyword is available only in the system context.
If a recovery configuration exists for the SSM, the adaptive security appliance displays it. Examine
the recovery configuration closely to ensure that it is correct, particularly the Image URL field. The
following is sample output from the show module recover command for an SSM in slot 1.
hostname# show module 1 recover
Module 1 recover parameters. . .
Boot Recovery Image: Yes
Image URL: tftp://10.21.18.1/ids-oldimg
Port IP Address: 10.1.2.10
Port Mask: 255.255.255.0
Gateway IP Address: 10.1.2.254
To create or modify the recovery configuration, use the hw-module module recover command with
the configure keyword:
Cisco Security Appliance Command Line Configuration Guide
Transferring an Image onto an SSM
22-19