System Configuration; Codec Configuration; Infotainment System Connection/Operation; Figure 20 Signal Flow - Inactive Call - Cisco MEDVIEW-C-30XS-A01 Installation And User Manual

Iron bow

Table of Contents

System Configuration

The MedView incorporates a Cisco Room Kit codec plus and for instruction how to manage the

codec system settings please refer to the Cisco Webex Codec plus Administrator Guide:

https://www.cisco.com/c/en/us/support/collaboration-endpoints/spark-room-kit-series/products-

maintenance-guides-list.html

NOTE: If you are managing the Cisco Webex Room Kit Plus Codec integrated into the CLINiC

using Cisco Unified Communications Manager (CallManager) or TelePresence Management

Suite (TMS), please ensure that the template used for the codec has the Serial Port Login

Required set to Disabled.

The MedView system incorporates an intelligent switching system that can be used to define the

signals being fed to the display depending upon whether is call is active or not. This facility

allows external information from an infotainment, or other source such as a feed from a cable box

or similar, to be fed through the system when it is in idle mode. When a call is made, from or to

the system, the switching feature will automatically feed the output of the codec to the display

interrupting the infotainment feed. When the call is terminated, the infotainment signal is

automatically fed to the display replacing the codec output signal.

The automated routing sequence is shown in Figures 20 and 21 below. Figure 20. Depicts and

inactive call state where the HDMI Signal fed to the Infotainment input is fed through the system

and is available at the HDMI output. The HDMI signal would generally incorporate audio, which

is fed through the system to the HDMI output.

Figure 20. Signal Flow – Inactive Call

Table of Contents