Cisco PIX 500 Series Configuration Manual page 945

Chapter 42 Monitoring the Security Appliance
hostname(config)# logging console {
Where the severity_level argument specifies the severity levels of messages to be sent to the console port.
You can specify the severity level number (0 through 7) or name. For severity level names, see the
"Severity Levels" section on page
appliance sends system log messages for level 3, 2, 1, and 0.
The message_list argument specifies a customized message list that identifies the system log messages
to send to the console port. For information about creating custom message lists, see the
System Log Messages with Custom Message Lists" section on page
The following example specifies that the adaptive security appliance should send to the syslog server all
system log messages with a severity level of level 3 (errors) and higher. The adaptive security appliance
will send messages with the severity of 3, 2, and 1.
hostname(config)# logging console errors
Sending System Log Messages to an E-mail Address
You can configure the adaptive security appliance to send some or all system log messages to an e-mail
address. When sent by e-mail, a system log message appears in the subject line of the e-mail message.
For this reason, we recommend configuring this option to notify administrators of system log messages
with high severity levels, such as critical, alert, and emergency.
Note To start logging to an e-mail address you define in this procedure, be sure to enable logging for all output
locations. See the
disable logging, see the
page
To designate an e-mail address as an output destination, perform the following steps:
To specify the system log messages to be sent to one or more e-mail addresses, enter the following
Step 1
command:
hostname(config)# logging mail { severity_level | message_list }
Where the severity_level argument specifies the severity levels of messages to be sent to the e-mail
address. You can specify the severity level number (0 through 7) or name. For severity level names, see
the
appliance sends system log messages for level 3, 2, 1, and 0.
The message_list argument specifies a customized message list that identifies the system log messages
to send to the e-mail address. For information about creating custom message lists, see the
System Log Messages with Custom Message Lists" section on page
The following example uses a message_list with the name "high-priority," previously set up with the
logging list command:
hostname(config)# logging mail high-priority
To specify the source e-mail address to be used when sending system log messages to an e-mail address,
Step 2
enter the following command:
hostname(config)# logging from-address email_address
OL-12172-03
"Enabling Logging to All Configured Output Destinations" section on page
"Disabling Logging to All Configured Output Destinations" section on
42-6.
"Severity Levels" section on page
severity_level message_list
|
42-24. For example, if you set the level to 3, then the adaptive security
42-24. For example, if you set the level to 3, then the security
Cisco Security Appliance Command Line Configuration Guide
Configuring and Managing Logs
}
"Filtering
42-18.
42-6. To
"Filtering
42-18.
42-9