Cisco PIX 500 Series Configuration Manual page 938

Using SNMP
Table 42-1 SNMP MIB and Trap Support
MIB or Trap Support
SNMP core traps
MIB-II
IF-MIB
RFC1213-MIB
SNMPv2-MIB
ENTITY-MIB
CISCO-IPSEC-FLOW-MONITOR-MIB
CISCO-REMOTE-ACCESS-MONITOR-MIB
CISCO-CRYPTO-ACCELERATOR-MIB
ALTIGA-GLOBAL-REG
Cisco Security Appliance Command Line Configuration Guide
42-2
Description
The adaptive security appliance sends the following SNMP core traps:
authentication—An SNMP request fails because the NMS did not
•
authenticate with the correct community string.
linkup—An interface has transitioned to the "up" state.
•
linkdown—An interface is down, for example, if you removed the
•
nameif command.
coldstart—The adaptive security appliance is running after a reload.
•
The adaptive security appliance supports browsing of the following
groups and tables:
system
•
The adaptive security appliance supports browsing of the following
tables:
• ifTable
• ifXTable
The adaptive security appliance supports browsing of the following table:
ip.ipAddrTable
•
The adaptive security appliance supports browsing the following:
• snmp
The adaptive security appliance supports browsing of the following
groups and tables:
entPhysicalTable
•
entLogicalTable
•
The adaptive security appliance supports browsing of the following traps:
config-change
•
fru-insert
•
fru-remove
•
The adaptive security appliance supports browsing of the MIB.
The adaptive security appliance supports browsing of the following traps:
start
•
stop
•
The adaptive security appliance supports browsing of the MIB.
The adaptive security appliance supports browsing of the following traps:
• session-threshold-exceeded
The adaptive security appliance supports browsing of the MIB.
The adaptive security appliance supports browsing of the MIB.
Chapter 42 Monitoring the Security Appliance
OL-12172-03