Cisco PIX 500 Series Configuration Manual page 266

Configuring Failover
Table 14-8
Field
Failover
Failover Unit
Failover LAN Interface
Unit Poll frequency
Interface Poll frequency
Interface Policy
Monitored Interfaces
Group 1 Last Failover at:
Group 2 Last Failover at:
This host:
Other host:
Role
System State
Group 1 State
Group 2 State
slot x
Cisco Security Appliance Command Line Configuration Guide
14-46
Status: Configured.
RPC services 0
TCP conn 33
UDP conn 0
ARP tbl 12
Xlate_Timeout 0
GTP PDP 0
GTP PDPMCB 0
SIP Session 0
Show Failover Display Description
Options
•
•
Primary or Secondary.
Displays the logical and physical name of the failover link.
Displays the number of seconds between hello messages sent to the
peer unit and the number of seconds during which the unit must receive
a hello message on the failover link before declaring the peer failed.
n seconds
The number of seconds you set with the failover polltime interface
command. The default is 15 seconds.
Displays the number or percentage of interfaces that must fail before
triggering failover.
Displays the number of interfaces monitored out of the maximum
possible.
The date and time of the last failover for each group in the following
form:
hh:mm:ss UTC DayName Month Day yyyy
UTC (Coordinated Universal Time) is equivalent to GMT (Greenwich
Mean Time).
For each host, the display shows the following information.
Primary or Secondary
•
•
•
•
Information about the module in the slot or empty.
0 0
0 0
0 0
0 0
0 0
0 0
0 0
0 0
On
Off
Active or Standby Ready
Active Time in seconds
Active or Standby Ready
Active Time in seconds
Chapter 14 Configuring Failover
0
0
0
0
0
0
0
0
OL-12172-03