Cisco PIX 500 Series Configuration Manual page 693

Chapter 30 Configuring Connection Profiles, Group Policies, and Users
You configure ACLs to permit or deny various types of traffic for this user. You then use the vpn-filter
command to apply those ACLs.
hostname(config-username)# vpn-filter {value ACL_name | none}
hostname(config-username)# no vpn-filter
hostname(config-username)#
Clientless SSL VPN does not use ACLs defined in the vpn-filter command.
Note
The following example shows how to set a filter that invokes an access list named acl_vpn for the user
named anyuser:
hostname(config)# username anyuser attributes
hostname(config-username)# vpn-filter value acl_vpn
hostname(config-username)#
Specifying the IP Address and Netmask
Specify the IP address and netmask to assign to a particular user. To remove the IP address, enter the no
form of this command.
hostname(config-username)# vpn-framed-ip-address { ip_address }
hostname(config-username)# no vpn-framed-ip-address
hostname(config-username)
The following example shows how to set an IP address of 10.92.166.7 for a user named anyuser:
hostname(config)# username anyuser attributes
hostname(config-username)# vpn-framed-ip-address 10.92.166.7
hostname(config-username)
Specify the network mask to use with the IP address specified in the previous step. If you used the
no vpn-framed-ip-address command, do not specify a network mask. To remove the subnet mask, enter
the no form of this command. There is no default behavior or value.
hostname(config-username)# vpn-framed-ip-netmask { netmask }
hostname(config-username)# no vpn-framed-ip-netmask
hostname(config-username)
The following example shows how to set a subnet mask of 255.255.255. 254 for a user named anyuser:
hostname(config)# username anyuser attributes
hostname(config-username)# vpn-framed-ip-netmask 255.255.255.254
hostname(config-username)
Specifying the Tunnel Protocol
Specify the VPN tunnel types (IPSec or clientless SSL VPN) that this user can use. The default is taken
from the default group policy, the default for which is IPSec. To remove the attribute from the running
configuration, enter the no form of this command.
hostname(config-username)# vpn-tunnel-protocol {webvpn | IPSec}
hostname(config-username)# no vpn-tunnel-protocol [webvpn | IPSec]
hostname(config-username)
OL-12172-03
Cisco Security Appliance Command Line Configuration Guide
Configuring User Attributes
30-77