Setting The Management Ip Address For A Transparent Firewall - Cisco PIX 500 Series Configuration Manual

Chapter 8 Configuring Basic Settings

Setting the Management IP Address for a Transparent Firewall

hostname# clock set hh : mm : ss { month day | day month } year
Where hh:mm:ss sets the hour, minutes, and seconds in 24-hour time. For example, set 20:54:00 for 8:54
pm.
The day value sets the day of the month, from 1 to 31. You can enter the day and month as april 1 or as
1 april, for example, depending on your standard date format.
The month value sets the month. Depending on your standard date format, you can enter the day and
month as april 1 or as 1 april.
The year value sets the year using four digits, for example, 2004. The year range is 1993 to 2035.
The default time zone is UTC. If you change the time zone after you enter the clock set command using
the clock timezone command, the time automatically adjusts to the new time zone.
This command sets the time in the hardware chip, and does not save the time in the configuration file.
This time endures reboots. Unlike the other clock commands, this command is a privileged EXEC
command. To reset the clock, you need to set a new time for the clock set command.
Setting the Management IP Address for a Transparent Firewall
Transparent firewall mode only
A transparent firewall does not participate in IP routing. The only IP configuration required for the
security appliance is to set the management IP address. This address is required because the security
appliance uses this address as the source address for traffic originating on the security appliance, such
as system messages or communications with AAA servers. You can also use this address for remote
management access.
For multiple context mode, set the management IP address within each context.
To set the management IP address, enter the following command:
hostname(config)# ip address ip_address [ mask ] [standby ip_address ]
This address must be on the same subnet as the upstream and downstream routers. You cannot set the
subnet to a host subnet (255.255.255.255). This address must be IPv4; the transparent firewall does not
support IPv6.
The standby keyword and address is used for failover. See Chapter 14, "Configuring Failover," for more
information.
Cisco Security Appliance Command Line Configuration Guide
8-5
OL-12172-03