Baxi Solo 3 PFL 30 Installation & Servicing Instructions Manual page 24

Air Box Blanking
Plate
Fig. 61
Air Duct
Fig. 64
Fig. 65
24
© Baxi Heating UK Ltd 2009
Blanking
Cap
Fig. 62
Flue Trim
Fig. 67
5.0 Installation
5.12
1. Remove the left or right hand air box blanking plate,
as appropriate, from the back plate air box by releasing
the three screws (Fig. 61).
2. Rotate the turret to face the selected opening
(Fig. 62) and remove the side blanking cap by pushing in
and turning anti-clockwise to release the bayonet fitting
Turret
(Fig. 61).
3.Locate the flared end of the flue duct over the
bayonet fitting on the turret, taking care not to damage
the 'O' ring. Lock the flue duct in place by pressing in
and turning clockwise (Fig. 63).
4. Engage the bayonet slots of the air duct over the
location lugs on the back plate opening and press and
turn clockwise to secure the air duct to the back plate
(Fig. 64).
5. Engage the flue and air ducts into the hole previously
Flue Duct
cut in the wall and through holes in other partitions
(cupboards, walls etc.).
Fig. 63
6. Secure the back plate to the wall at the previously
drilled anchorage points with suitable screws. Before
finally tightening the screws, check that the assembly is
level.
7. Take the flue terminal assembly and pass through the
cut hole from outside. Engage on the flue and air ducts.
Slide the flues together to the desired wall thickness,
tape the outer duct sections together with the tape
provided ensuring a good seal is made.
8. In order to increase security of the flue, the bayonet
tags may be deformed to secure the flue in position.
9. Make good between the wall and the air duct inside
and outside the building if the internal fitting kit has not
been used (Fig. 65).
10. The flue trim provided may be fitted if required, to
neaten up the make-up around the terminal (Fig. 67).
Edge Clip
11. To fit the flue terminal trim:
a) The trim should be fitted once the flue is secure.
b) Take the three edge clips from the kit and fit them
equi-spaced onto the inner flange of the trim (Fig. 66).
Fig. 66 c) With the flanges towards the wall pass the trim over
the terminal. If required a bead of sealant may be
applied to the rear face of the trim.
d) Push firmly on the trim to ensure the edge clips
engage on the flue.
Flue Trim
Method B