Baxi Solo 3 PFL 30 Installation & Servicing Instructions Manual page 19

5.0 Installation
5.7 Fitting the Back Plate
1. Engage the assembly into the hole previously cut in
the wall and slide in place (Fig. 34).
2. Secure the assembly to the wall at the previously
drilled anchorage points with suitable screws (Fig. 34).
Before finally tightening the screws, check that the
assembly is level.
3. Make good between the wall and the air duct outside
the building if the internal fitting kit has not been used
(Fig. 35).
4. The flue trim provided may be fitted if required, to
neaten the make-up around the terminal (Fig. 37).
5. To fit the flue terminal trim:
a) The trim should be fitted once the flue is secure.
Fig. 34
b) Take the three edge clips from the kit and fit them
equi-spaced onto the inner flange of the trim (Fig. 36).
c) With the flanges towards the wall pass the trim over
the terminal. If required a bead of sealant may be
applied to the rear face of the trim.
d) Push firmly on the trim to ensure the edge clips
engage on the flue.
Fig. 35
Edge Clip
Flue Trim
Fig. 36
Fig. 37
Flue Trim
19
© Baxi Heating UK Ltd 2009