Ricoh OR-C1 Field Service Manual page 585

PnP Model Name
This SP sets the model name to be used by the USB PnP when "Function Enable (Level 2)
6
is set so the USB Serial No. can have a common name (SP5844-5).
Default: Laser Printer (up to 20 characters allowed).
PnP Serial Number
This SP sets the serial number to be used by the USB PnP when "Function Enable (Level 2)
set so the USB Serial No. can have a common name (SP5844-5).
Default: None (up to 12 characters allowed for entry).
7
• Make sure that this entry is the same as the serial number in use.
• At initialization the serial number generated from the model name is used, not the
setting of this SP code.
• At times other than initialization, the value set for this SP code is used.
Notify Unsupport
This SP determines whether an alert message appears on the control panel when a a
USB device (unsupported device) that cannot use an A-connector is connected.
[0 to 1 / 1 / 1]
0: Function enable
100
1: Function disable
• An unsupported device is a device that cannot use the functions of the USB device.
For example, a USB mouse cannot be used even if it connected.
• If the PictBridge option is not mounted, even if a digital camera is connected it
cannot be used because it is an unsupported device.
Delivery Server Setting
5845*
These are delivery server settings.
FTP Port No.
1
[0 to 65535 / 3670 / 1]
IP Address (Primary)
Use this SP to set the Scan Router Server address. The IP address under the transfer tab
2
can be used with the initial system setting.
[0 to FFFFFFFF/ 0 / 1]
System SP Tables-5
4
227