Working - CanyCom CM1802 Operator's Manual

6
Cutting blade shield
Intermediate
speed
Throttle lever
Operation

6.9 Working

1. Make sure cutting blade shield is closed.
2. Stop machine and move throttle lever to a position between
3. Move cutting height adjust lever to position [5].
Cutting height
adjust lever
Never put any part of your body under cutter
blade shield. Severe injury or death may result.
• When using machine for the first time, select
a flat ground and operate slowly so that
each cutting paths overlaps.
• When cutting around obstacles, always position
trees, posts, and other obstacles on the left
side of the machine. (Make leftward turning.)
• Before carrying out work, be sure to read
Operating in Chapter 3 Safety. (
[High speed] and [Low speed].
– 24 –
DANGER
N O T E
Page 5)