Troubleshooting; Troubleshooting Chart - CanyCom CM1802 Operator's Manual

9.

Troubleshooting

• If any malfunction or abnormal operation is found, immediately stop using the machine and make an
appropriate repair referring to the troubleshooting chart shown below. If the malfunction is not listed in
the chart or the suggested repair does not solve the problem, consult your dealer or one of our service
centers.
• Some repair contents require specialized service knowledge. Request your dealer or one of our service
centers for such repairs.

9.1 Troubleshooting Chart

Area
Engine does not start
Hard to start (Difficult in start-
Engine
ing)
Troubleshooting
Malfunction Possible cause
• Rotary clutch lever is not in
the "OFF" position. (Safety
device is actuated.)
• Brake pedal is not depressed.
(Safety device is working.)
• Battery is over-discharged.
• Battery cable is disconnected.
• Fuse is blown.
• Open circuit or contact failure
of wiring
• Lack of fuel
• Air or water in fuel
• Excessive intake of fuel
• Engine oil level is wrong or
wrong engine oil (High oil vis-
cosity)
• Poor ignition due to dirt on
spark plug or poor sparking
• Insufficient capacity of battery
(Poor electric starting)
• Impurities in fuel circuit
– 51 –
Corrective action
Put the lever to [OFF]. (
Page 16)
Depress brake pedal.
Charge battery.( Page 37)
Replace battery
Connect cable.
Replace.
Repair. (Consult dealer.)
Fill. ( Page 14)
Check pipe and tightening
band. Repair or replace.
Wait a while and start again.
Fill or change. ( Page 32)
Clean or replace.( Page 40)
Replenish battery fluid.(
Page 37)
Charge battery.( Page 37)
Clean fuel cock.( Page 41)
9