Spark Plugs - CanyCom CM1802 Operator's Manual

7
Spark plug cap
<Front>
Damage
Wear, car-
bon deposit
Degree of burning
Maintenance
7.7.2
Inspecting
1. Remove spark plug cap.
<Rear>
2. Remove spark plug with a plug wrench.
Breakage
3. Check plug for the following points and clean or replace
Cleaning
1. Clean spark plug with a wire brush or plug cleaner.
2. With sandpaper, adjust spark gap as specified.
3. Install spark plug.
– 40 –

Spark Plugs

N O T E
Do not pull cable when removing spark plug
cap. Always hold spark plug cap.
it as necessary. (Specifications for spark plug :
11)
• Breakage of insulator
• Worn electrode
• Carbon deposit
• Damage on gasket or thread
• Condition of insulator around electrode
Standard spark gap : 0.9 to 1.0 mm
Page